Install the OCP 3.0 Ethernet adapter

Use this information to install the OCP 3.0 Ethernet adapter.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

CAUTION

Make sure that all server power cords are disconnected from their power sources before performing this procedure.

Before installing the OCP 3.0 Ethernet adapter, touch the static-protective package that contains the new OCP 3.0 Ethernet adapter to any unpainted surface on the outside of the server. Then, take the new OCP 3.0 Ethernet adapter out of the package and place it on a static-protective surface.

To install the OCP 3.0 Ethernet adapter, complete the following steps:

Figure 1. OCP 3.0 Ethernet adapter installation

1. Push the OCP 3.0 Ethernet adapter as shown to insert it into the connector on the system board.
2. Tighten the thumbscrew to secure the card.

   Figure 2. OCP module (two connectors)	Figure 3. OCP module (four connectors)
   Note The OCP 3.0 Ethernet adapter provides two or four extra Ethernet connectors for network connections. Any of the connectors (connector 1 by default) on the OCP module can function as a shared management connector.