Install the 2.5-inch middle drive cage
Use this information to install the middle 2.5-inch drive bay.
About this task
The middle drive cage is supported on some server models at certain conditions. For detailed information, see Technical rules.
Read Installation Guidelines to ensure that you work safely.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.
- Connect cables to the backplane.
- Align the bottom of the backplane with the studs at the bottom of the drive cage. Rotate the backplane to vertical position so that the holes in the backplane pass through the pins on the drive cage, and press the backplane into position. The release latches will secure the backplane in place.Figure 1. Installing the backplane
- Install the middle drive cage onto chassis and drives into drive bays. Then close the handle.Figure 2. Installing the middle 2.5-inch drive cage and drives
Put the rear pins into the chassis slots.
Rotate the front of the drive cage down into place.
Install drives into the middle drive cage. See Install a hot-swap drive.
Press the latch as shown.
Rotate the handle to close it.