Remove the intrusion switch
Follow instructions in this section to remove the intrusion switch.
About this task
Attention
- Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
- Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
- If the server is installed in a rack, remove it from the rack. See Remove the server from rails.
Procedure
- Make preparation for this task.
- Remove the front top cover. See Remove the front top cover.
- Remove the rear top cover. See Remove the rear top cover.
- Remove the rear air baffle. See Remove the rear air baffle.
- Remove the intrusion switch.
Disconnect the intrusion switch cable from the system board assembly.
Pull the intrusion switch out of the intrusion switch bracket.Figure 1. Intrusion switch removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Demo video
Give documentation feedback