Skip to main content

Remove the management NIC adapter

Follow instructions in this section to remove the management NIC adapter.

About this task

Attention

Procedure

  1. Make preparation for this task.
    1. Access the Lenovo XClarity Controller; then, select Network in BMC Configuration and disable Ethernet Port 2.
    2. Remove the front top cover. See Remove the front top cover.
    3. Remove the rear top cover. See Remove the rear top cover.
    4. Depending on the server model, remove the following PCIe riser.
      • If the server is installed with three PCIe risers, remove the PCIe riser 1. See Remove a PCIe riser.
      • If the server is installed with four PCIe risers, remove the PCIe riser A. See Remove a PCIe riser.
  2. Disconnect the cable from the management NIC adapter.
  3. Remove the management NIC adapter.
    1. Loosen the screw that secures the management NIC adapter.
    2. Press and hold the blue latch.
    3. Push the management NIC adapter by the latch out from the chassis.
      Figure 1. Management NIC adapter removal
      Management NIC adapter removal

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube