Skip to main content

Removing a SAS/SATA 8 Pac HDD option

Use this information to remove a SAS/SATA 8 Pac HDD option.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To remove a SAS/SATA 8 Pac HDD option, complete the following steps.

  1. Remove the bezel (see Removing the bezel).
  2. Remove the left side cover (see Removing the left-side cover).
  3. Pull the hard disk drives and filler panels out of the server slightly to disengage them from the hard disk drive backplane.
  4. Remove the 2.5-inch hot-swap SAS/SATA hard disk drive backplane (see Removing the 2.5-inch hard disk drive backplane).