Removing the system battery

Use this information to remove the system battery.

The following illustration shows the location of the system battery.

Figure 1. System battery

If you are replacing a server component in the server, you need to turn off the server and peripheral devices, and disconnect the power cords and all external cables.

1. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
   Attention

   Do not allow the server to fall over.
2. Unlock and remove the left-side cover (see Removing the left-side cover).
3. Remove the air baffle (see Removing the air baffle).
4. Remove the system battery:
   1. If there is a rubber cover on the battery holder, use your fingers to lift the battery cover from the battery connector.
   2. Use one finger to tilt the battery horizontally out of its socket, pushing it away from the socket.
      Attention

      Neither tilt nor push the battery by using excessive force.
   3. Use your thumb and index finger to lift the battery from the socket.
      Figure 2. System battery removal
      
      
      Attention

      Do not lift the battery by using excessive force. Failing to remove the battery properly may damage the socket on the system board. Any damage to the socket may require replacing the system board.
5. Dispose of the battery as required by local ordinances or regulations.