Skip to main content

Removing a hot-swap fan

Use this information to remove a hot-swap fan in the server.

Attention
To avoid unexpected system shutdown, ensure that you lay the server on its side with the cover facing up before you start.
The server comes with two 92 mm x 38 mm hot-swap fans in the fan cage assembly. The following instructions can be used to install any hot-swap fan in the server.
Note
  1. Figure 1. The available fan sockets in the server
    The available fan sockets in the server
  2. You can order the two additional fans for redundant cooling.
Attention
Static electricity that is released to internal server components when the server is powered-on might cause the server to halt, which might result in the loss of data. To avoid this potential problem, always use an electrostatic-discharge wrist strap or other grounding system when you work inside the server with the power on.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To remove a hot-swap fan, complete the following steps.

  1. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
  2. Unlock and remove the left-side cover (see Removing the left-side cover).
  3. Open the fan locking and pull it up from the fan cage assembly.
    Figure 2. Open the fan-locking handle
    Open the fan-locking handle
  4. If you are instructed to return the hot-swap fan, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.