Skip to main content

Remove the intrusion switch with cable

Follow the instructions in this section to remove the intrusion switch with cable.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention

Procedure

  1. Make preparation for this task.
    1. Remove the top cover. See Remove the top cover.
    2. Remove all the PCIe assemblies. If the configuration comes with PCIe riser 2 and internal drives, remove all the internal drives, and lift the internal drive backplane before removing PCIe riser 2. See Remove the PCIe riser assembly.
    3. Remove the processor air baffle. See Remove the processor air baffle.
  2. Disconnect the intrusion switch cable from the system board.
  3. Loosen the captive screw that secures the intrusion switch, and pull the intrusion switch up to remove it.
    Figure 1. Removing the intrusion switch with cable

After this task is completed
  • Install a replacement unit. See Install the intrusion switch with cable.

  • If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo Video

Watch the procedure on YouTube