Skip to main content

Install an intrusion switch

Use this information to install an intrusion switch.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Remove the system fan-pack 2.
    Figure 1. Removing fan-pack 2

  2. Install the intrusion switch.
    Figure 2. Installing the intrusion switch

    1. Insert the intrusion switch into the cage and route the cable into the cable clip.
    2. Connect the intrusion switch cable.
  3. Connect the cable of the intrusion switch to the intrusion switch connector on the processor board. See Internal cable routing.
  4. Re-install the system fan-pack 2. Align the four corners of the fan-pack to its socket and put it down.
    Figure 3. Re-installing fan-pack 2

After you finish

Complete the parts replacement. See Complete the parts replacement.