Remove an EDSFF drive
Use this information to remove an EDSFF drive.
About this task
- Ensure that you have backed up data on your drive, especially if it is part of a RAID array.
Before you make changes to drives, RAID adapters, or drive backplanes, back up all important data that is stored on the drives.
Before you remove any component of a RAID array, back up all RAID configuration information.
If one or more NVMe drives are to be removed, it is recommended to disable them first in Safely Remove Hardware and Eject Media (Windows) or filesystem (Linux). Log in to XClarity Controller and go to the Storage menu to identify and locate the drive type and corresponding drive bay number. If the drive bay numbers come with the term “NVMe”, it indicates that the installed drives are NVMe drives.
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.
To ensure that there is adequate system cooling, do not operate the server for more than two minutes without either a drive or a drive filler installed in each bay.
Procedure
- Remove the EDSFF drive cage cover.Figure 1. EDSFF drive cage cover removal
Open the handle as shown.
Grasp the handle and remove the drive cage cover.
- Remove the EDSFF drive.Figure 2. EDSFF drive removal
- Slide the release latch as shown to open the drive tray handle.
- Grasp the handle and slide the drive out of the drive bay.
After you finish
Install a new drive or a drive cage cover to cover the drive bay.
Figure 3. EDSFF drive filler installation
Install the drive cage cover.
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Demo video