Skip to main content

Remove a 2.5''/3.5'' hot-swap drive

Use this information to remove a 2.5''/3.5'' hot-swap drive.

About this task

The following describes the information that you must consider for this task:
  • Ensure that you have backed up data on your drive, especially if it is part of a RAID array.

    • Before you make changes to drives, RAID adapters, or drive backplanes, back up all important data that is stored on the drives.

    • Before you remove any component of a RAID array, back up all RAID configuration information.

  • If one or more NVMe drives are to be removed, it is recommended to disable them first in Safely Remove Hardware and Eject Media (Windows) or filesystem (Linux). Log in to XClarity Controller and go to the Storage menu to identify and locate the drive type and corresponding drive bay number. If the drive bay numbers come with the term “NVMe”, it indicates that the installed drives are NVMe drives.

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • To ensure that there is adequate system cooling, do not operate the server for more than two minutes without either a drive or a drive filler installed in each bay.

Procedure

  1. If the security bezel is installed, remove it first. See Remove the security bezel.
  2. Remove a hot-swap drive.


    1. Slide the release latch to the left to open the drive tray handle.
    2. Open the drive handle.
    3. Slide the drive out of the drive bay.

After you finish

  1. Install a drive filler or a new drive (Install a 2.5''/3.5'' hot-swap drive) to cover the drive bay.

    Table 1. Install a drive filler
    Note
    The installation steps vary with drive filler types.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube