Top view
This section provides information about the top view of the server.
The following illustrations show the top view of the server without any air baffle, middle cage, or rear cage installed.
The following illustrations show the server rear configuration with four riser assemblies. The server rear configurations vary by server model. For details, see Rear view.
Top view with standard heat sinks
 | 1 Riser assemblies 2 System board assembly 3 Processor and heat sink module (PHM) 4 Memory modules 5 System fans 6 Intrusion switch 7 Internal CFF adapter 8 Front backplane(s) |
The illustration shows the server with internal CFF adapters which are available only in the 2.5-inch chassis. In some configurations, there might be installed with a RAID flash power module. For details, see Table 1.
Top view with Processor Neptune Core Module
The illustration below singles out the module from other components in the chassis. The parts contained depend on the configuration of the server.
 | 1 Outlet hose 2 Inlet hose 3 Hose holder 4 Leakage detection sensor module 5 Cold plate assembly 6 Riser cage for Neptune Core Module |
Top view with Compute Complex Neptune Core Module
The illustration below singles out the module from other components in the chassis. The parts contained depend on the configuration of the server.
 | 1 Outlet hose 2 Inlet hose 3 Hose holder 4 Leakage detection sensor module 5 Cold plate assembly 6 Riser cage for Neptune Core Module |