Skip to main content

Remove the top cover intrusion switch

Follow the instructions in this section to remove the top cover intrusion switch.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices, disconnect the power cords from the primary chassis, then disconnect the power cords from the secondary chassis. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • If the server is installed in a rack, remove the server from the rack. See Remove the server from rails.

Procedure

  1. Remove the front top cover. See Remove the front top cover.
  2. Disconnect the intrusion switch cable from the lower processor board (MB).
    Figure 1. Disconnecting intrusion switch

    Disconnecting intrusion switch
  3. Remove the top cover intrusion switch.
    Figure 2. Removing top cover intrusion switch
    Removing top cover intrusion switch
    1. Loosen the captive screw.
    2. Remove the intrusion switch cover.
    3. Remove the intrusion switch from the chassis.

After you finish

  1. Install a replacement unit. See Install the top cover intrusion switch.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube