Skip to main content

Install a GPU adapter link bridge (NVLink bridge)

Follow the instructions in this section to install a GPU adapter link bridge (NVLink bridge).

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Remove the NVLink covers.
    Figure 1. Removal of the NVLink covers
    NVLink covers removal
  2. Note the orientation of the NVLink bridge; then, install the NVLink bridge as shown.
    Figure 2. Installation of an NVLink bridge
    NVLink bridge installation

After this task is completed

  1. Reinstall the air baffle, if necessary. See Install an air baffle.

  2. Reinstall all the flash power modules, if necessary. See Install a flash power module.

  3. Reinstall the server cover. See Install a server cover.

  4. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube