Skip to main content

Replacing the LCD system information display panel

Use this information to replace the LCD system information display panel.

To install the LCD system information display panel, complete the following steps.

Note
The LCD system information display panel is available only in the ten 2.5-inch hot-swap hard disk drive server configuration.
  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
  3. 1 Pull the tab on the LCD retention bracket to the left to disengage the retention bracket. 2 Rotate the retention bracket to remove it from the server.
    Figure 1. Retention bracket removal
    Retention bracket removal
  4. From inside the media cage, carefully insert the LCD system information display panel into place.
    Figure 2. LCD system information display panel installation
    LCD system information display panel installation
  5. Carefully insert the tab on the retention bracket into the slot on the LCD panel assembly and rotate it counterclockwise until it clicks into place.
    Figure 3. Retention bracket installation
    Retention bracket installation
  6. Connect the LCD system information display panel cable to the back of the LCD system information display panel.
  7. Carefully push the media cage back into the chassis (see Replacing the media cage). Remember to reconnect the cables that were removed from the system board.
  8. Reinstall the cover (see Replacing the cover).
  9. Slide the server into the rack.
  10. Reconnect the power cords and any cables that you removed.
  11. Turn on the peripheral devices and the server.