Skip to main content

Replacing the DVD drive

Use this information to replace the DVD drive.

The following notes describe the type of drives that the server supports and other information that you must consider when you install a drive. For a list of supported drives, see the Lenovo ServerProven website.

  • Locate the documentation that comes with the drive and follow those instructions in addition to the instructions in this chapter.
  • Make sure that you have all the cables and other equipment that are specified in the documentation that comes with the drive.
  • The server supports one ultra-slim SATA DVD drive.

To install a DVD drive, complete the following steps:

Note
The DVD drive is supported on the ten 2.5-inch hot-swap or simple-swap hard disk drive model.
  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
    Note
    When you disconnect the power source from the server, you lose the ability to view the LEDs because the LEDs are not lit when the power source is removed. Before you disconnect the power source, make a note of which LEDs are lit, including the LEDs that are lit on the operation information panel and LEDs inside the server on the system board.
  3. Remove the cover (see Removing the cover).
  4. Remove the DVD drive filler panel if it is installed. Locate the blue release tab on the rear of the DVD drive filler panel; then, while you press the tab, push the DVD drive filler panel out of the drive bay.
    Figure 1. DVD drive filler panel removal for 2.5-inch hard disk drive server models
    DVD drive filler panel removal for 2.5-inch hard disk drive server models
    Figure 2. DVD drive filler panel removal for 3.5-inch hard disk drive server models
    DVD drive filler panel removal for 3.5-inch hard disk drive server models
  5. Remove the retention clip from the side of the DVD drive filler panel. Save the DVD drive filler panel for future use.
    Note
    If you are installing a DVD drive that contains a laser, observe the following safety precautions.
    Statement 3

    CAUTION
    When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are installed, note the following:
    • Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
    • Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

    exclamation symbol
    DANGER
    danger
    Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following.

    Laser radiation when open. Do not stare into the beam, do not view directly with DVD instruments, and avoid direct exposure to the beam.


    laser class 1 symbol
  6. Touch the static-protective package that contains the new DVD drive to any unpainted metal surface on the server; then, remove the DVD drive from the package and place it on a static-protective surface.
  7. Follow the instructions that come with the drive to set any jumpers or switches.
  8. Attach the drive retention clip that you removed from the DVD drive filler panel to the side of the new DVD drive.
    Figure 3. DVD drive retention clip installation
    DVD drive retention clip installation

  9. Align the DVD drive in the drive bay and slide the DVD drive into the DVD drive bay until the DVD drive clicks into place.
    Figure 4. DVD drive installation for 2.5-inch hard disk drive server models
    DVD drive installation for 2.5-inch hard disk drive server models
    Figure 5. DVD drive installation for 3.5-inch hard disk drive server models
    DVD drive installation for 3.5-inch hard disk drive server models
  10. Reconnect the power cords and any cables that you removed.
  11. Turn on the peripheral devices and the server.