Removing the front video connector assembly
Use this information to remove the front video connector assembly.
To remove the front video connector assembly, complete the following steps:
- Read the safety information that begins on Safety and Installation guidelines.
- Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
- Remove the cover (see Removing the cover).
- Remove the media cage (see Removing the media cage).
- Loosen the screws that secure the front video connector assembly to the media cage; then, remove the assembly from the media cage.NoteRefer to the illustration that applies to your particular server configuration.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 1. Front video connector assembly removal for eight 2.5-inch hot-swap or simple-swap hard disk drive server configurationTen 2.5-inch hot-swap hard disk drive server configuration:
Figure 2. Front video connector assembly removal for ten 2.5-inch hot-swap hard disk drive server configurationFour 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 3. Front video connector assembly removal for four 3.5-inch hot-swap or simple-swap hard disk drive server configuration - If you are instructed to return the front video connector assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Give feedback