Removing the front USB connector assembly
Use this information to remove the front USB connector assembly.
To remove the front USB connector assembly, complete the following steps:
- Read the safety information that begins on Safety and Installation guidelines.
- Turn off the server and peripheral devices and disconnect all power cords; then, remove the cover (see Removing the cover).
- Remove the media cage (see Removing the media cage).
- Remove the front USB connector assembly from the media cage.Note
- Refer to the illustration that applies to your particular server configuration.
- The eight 2.5-inch and four 3.5-inch hot-swap or simple-swap hard disk drive server configuration supports three USB connectors. The ten 2.5-inch hot-swap hard disk drive server configuration supports only two USB connectors.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 1. Front USB connector assembly removal for eight 2.5-inch hot-swap or simple-swap hard disk drive server configurationTen 2.5-inch hot-swap hard disk drive server configuration:
Figure 2. Front USB connector assembly removal for ten 2.5-inch hot-swap hard disk drive server configurationFour 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 3. Front USB connector assembly removal for four 3.5-inch hot-swap or simple-swap hard disk drive server configuration - If you are instructed to return the front USB connector assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Give feedback