Skip to main content

Install the rear OCP interposer card

Follow the steps in this section to install a rear OCP interposer card.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. Install the rear OCP interposer card.
    Figure 1. Installing the rear OCP interposer

    1. Slide the rear OCP interposer into the slot until it is fully seated.
    2. Tighten the screw to secure the rear OCP interposer.
  3. Connect the cables to the rear OCP interposer card. For more details, see Internal cable routing.

After you finish

Complete the parts replacement. See Complete the parts replacement.