Skip to main content

Remove the rear OCP interposer card

Follow the steps in this section to remove a rear OCP interposer card.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. Disconnect the cables on the rear OCP interposer card. For more details, see Internal cable routing.
  3. Remove the rear OCP interposer card.
    Figure 1. Removing the rear OCP interposer card

    1. Loosen the screw that secures the rear OCP interposer card.
    2. Press and hold the blue latch. And pull the rear OCP interposer card by the latch out from the chassis.

After you finish

  1. Install a new rear OCP interposer card. See Install the rear OCP interposer card.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.