Skip to main content

Remove the 2.5-inch rear drive assembly

Use this information to remove the 2.5-inch rear drive assembly.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. Remove the drives or drive fillers installed in the 2.5-inch rear drive cage. See Remove a 2.5-inch hot-swap drive.
  3. Disconnect the 2.5-inch rear drive cage cables from the processor board or the PCIe adapter. See Internal cable routing.
  4. Hold the two blue touch points and directly lift the 2.5-inch rear drive cage out of the chassis.
    Figure 1. 2.5-inch rear drive cage removal
    2.5-inch rear drive cage removal

  5. If the rear backplane is reused, remove the rear backplane. See Remove the 2.5-inch rear drive backplane.

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.