Skip to main content

Install the front 16-EDSFF drive backplane

Use this information to install the backplane for front 16 EDSFF drives.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the backplane to any unpainted surface on the outside of the server. And then, take the backplane out of the package and place it on a static-protective surface.
  2. Connect the cables to the backplane. See Internal cable routing.
  3. Put the backplane down into place.
    Figure 1. Installation of backplane for 16 EDSFF drives
    Installation of backplane for 16 EDSFF drives

    1. Align the hole on the backplane with the pin on the chassis, place it down, and slightly slide it as shown.
    2. Tighten the screw to secure the backplane.
  4. Connect the cables to the system board or expansion slots. See Internal cable routing.If the cable connectors come with protective dust caps, make sure to remove them before plugging in.

After you finish

  1. Reinstall all the drives and drive cages into the drive bays. See Install a hot-swap EDSFF drive.

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube