Skip to main content

Remove the front 2.5-inch drive backplane

Use this information to remove the backplane for ten 2.5 inch hot-swap drives.

About this task

The following describes how to remove the backplane for ten 2.5-inch hot-swap drives. You can remove the backplane for four or eight 2.5-inch hot-swap drives in the same way.

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.


  1. Remove the top cover. See Remove the top cover.
  2. Remove all the installed drives and drive fillers from the drive bays. See Remove a 2.5-inch hot-swap drive.
  3. Grasp the backplane and carefully lift it out of the chassis.
    Figure 1. Removal of backplane for ten 2.5-inch hot-swap drives
    Removal of backplane for ten 2.5-inch hot-swap drives

  4. Disconnect the cables from the backplane. See Internal cable routing.

After you finish

If you are instructed to return the old backplane, follow all packaging instructions and use any packaging materials provided.

Demo video

Watch the procedure on YouTube