Remove the firmware and RoT security module

Follow instructions in this section to remove the ThinkSystem V3 Firmware and Root of Trust Security Module (firmware and RoT security module).

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Important

This task must be operated by trained technicians that are certified by Lenovo Service. Do not attempt to remove or install the part without proper training and qualification.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top covers, or remove the server from the rack. See Remove the server from rails.

Procedure

1. Make preparation for the task.
   1. Perform OneCLI commands to back up the UEFI settings. See OneCLI commands that save configuration settings.
   2. Perform both OneCLI commands and XCC actions to back up the XCC settings. See OneCLI commands that save configuration settings and Using XCC to back up the BMC configuration.
   3. Remove the front top cover. See Remove the front top cover.
   4. Remove the rear top cover. See Remove the rear top cover.
   5. Remove the crossbar. See Remove the crossbar.
   6. Remove all the PCIe risers. See Remove the PCIe riser.
2. Remove the firmware and RoT security module.
   Figure 1. Firmware and RoT security module removal
   
   
   1. Loosen the two screws on the firmware and RoT security module.
   2. Lift the firmware and RoT security module out of the chassis.