Skip to main content

Remove the intrusion switch

Follow the instructions in this section to remove an intrusion switch.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • If the server is in a rack, remove it from the rack.

  • If foot stands are installed on the server, pivot them inwards and lay the server on its side for easier operation.

Procedure

  1. Make preparations for this task.
    1. Remove the server cover. See Remove the server cover.
    2. If necessary, remove all flash power modules. See Remove a flash power module.
    3. Remove the air baffle. See Remove the air baffle.
  2. Disconnect the intrusion switch cable from the system board.
  3. Press the two intrusion switch pinch tabs towards each other; then, carefully pull out the intrusion switch to remove it from the frame.
    Figure 1. Removal of an intrusion switch
    Intrusion switch removal

After this task is completed

  1. Install a replacement unit. See Install an intrusion switch.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube