Skip to main content

Replacing a RAID adapter flash power module

Use this information to replace a RAID adapter flash power module.

When you install any RAID adapter that comes with a flash power module, the flash power module must be installed remotely in the server to prevent it from overheating. The RAID adapter flash power module must be installed in the trays on top of the USB/video assembly (above the operator information panel). To install the RAID adapter flash power module remotely in the server, complete the following steps:

  1. Read the safety information and installation guidelines, see Safety and Installation guidelines.
  2. Place the new flash power module into the battery/flash power module tray.
  3. Connect the flash power module cable to the cable connector on the new flash power module. Replace the retention clip by pressing down on the retention clip until it snaps in place to hold the flash power module firmly in place.

    replace raid flash power module

  4. Install the cover.
  5. Slide the server into the rack.
  6. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.