Removing a RAID adapter flash power module

Use this information to remove a RAID adapter flash power module.

If a RAID adapter flash power module is installed remotely in the server and you need to replace the RAID adapter flash power module, complete the following steps:

1. Read the safety information and installation guidelines, see Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
3. Remove the top cover (see Removing the server top cover).
4. Locate the battery/flash power module trays on top of the USB/video assembly (above the operator information panel).
5. Press the tray retention clip tab to the right or left and remove the retention clip. See
6. Disconnect the flash power module cable from the failed flash power module and remove it from the tray.

   

7. If you are instructed to return the flash power module, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.