Replacing a USB embedded hypervisor flash device

Use this information to replace a USB embedded hypervisor flash device.

To install a USB hypervisor flash device, complete the following steps:

1. Read the safety information and installation guidelines, see Safety and Installation guidelines.
2. Align the USB flash device with the connector on the system board and push it into the connector until it is firmly seated.
3. Slide the lockbar up to the locked position until the lockbar is seated firmly.

   

4. Reinstall the PCIe riser-card assembly (see Replacing a PCI riser-card assembly).
5. Reconnect the cables to the adapters, if any were installed in the PCI riser-card.
6. Reconnect the power cord and any cables that you removed.
7. Install the cover (see Replacing the server top cover).
8. Slide the server into the rack.
9. Turn on the peripheral devices and the server.