Install the rear drive assembly

Use this information to install the rear drive assembly.

About this task

Attention

Read Installation guidelines to ensure that you work safely.
Power off the server and disconnect all power cords for this task.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

Touch the static-protective package that contains the rear hot-swap drive cage to any unpainted surface on the outside of the server. Then, take the rear hot-swap drive cage out of the package and place it on a static-protective surface.
Gently press and hold the tab on the rear hot-swap drive cage as shown and remove the air baffle from the rear hot-swap drive cage.
Figure 1. Air baffle removal
Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive cage.
Figure 2. Rear backplane installation
Connect the cables to the backplane. See 2.5-inch/3.5-inch drive backplane (power) and 2.5-inch/3.5-inch drive backplane (signal).
Install the air baffle into the rear hot-swap drive cage as shown.
Figure 3. Air baffle installation
Align the pins on the rear hot-swap drive cage with the corresponding hole and slot in the chassis. Then, lower the rear hot-swap drive cage into the chassis until it is fully seated.
Figure 4. Rear hot-swap drive cage installation
Connect the cables to the system board or expansion slots. See 2.5-inch/3.5-inch drive backplane (power) and 2.5-inch/3.5-inch drive backplane (signal).

After you finish

Install the drives or drive fillers into the rear drive assembly. See Install a 2.5/3.5-inch hot-swap drive.

Demo video

Watch the procedure on YouTube

Give documentation feedback