Skip to main content

DDR5 RDIMMs mixed with CXL memory modules

This section contains information about how to install DDR5 RDIMMs mixed with CXL memory modules (CMMs) properly.

  • CMM configurations are 1 DPC (slot 0) only for native DDR5 DIMMs.

  • CMM channel: number of devices per root port, with root ports separated by +, e.g. 2+2 = one root port populated with two devices per root port

  • CMM modes:

    • 1LM + Vol = Native DDR5 (1LM) and (volatile) CMM visible to software (SW) as separate tiers, separately interleaved

    • Hetero x12 = DDR5 and (volatile) CMM interleaved together in one 12-way set

    Note
    The Hetero mode is not supported with LCC processors. For specific models of LCC processors, see the Processors section in SR630 V4 Product Guide.

  • For CMM configurations, see Cable routing for E3.S drive backplanes.

  • To set the CMM mode, go to UEFI Setup > System Settings > Memory > CXL Memory Module > Memory Mode.

Table 1. Installation rule for one processor (CPU 0)
DDR5 RDIMMsCMM
Slot 0 DIMMsSlot 1 DIMMsRDIMM modeCMM modeCMM capacity per moduleCMM channels
8 x 64 GB (2Rx4)N/AIndependent/mirroring1LM+Vol128 GB2 or 2+2
8 x 64 GB (2Rx4)Independent/mirroring1LM+Vol128 GB2 or 2+2
8 x 96 GB (2Rx4)N/AMirroring1LM+Vol96 GB2 or 2+2
8 x 96 GB (2Rx4)Mirroring1LM+Vol96 GB2 or 2+2
8 x 128 GB (2Rx4)N/AIndependent/mirroring1LM+Vol128 GB2 or 2+2
N/AIndependentHetero128 GB2+2
8 x 128 GB (2Rx4)Independent/mirroring1LM+Vol128 GB2 or 2+2
Table 2. Installation rule for two processors (CPU 0 and CPU 1)
DDR5 RDIMMsCMM per socket
Slot 0 DIMMsSlot 1 DIMMsRDIMM modeCMM modeCMM capacity per moduleCMM channels
16 x 64 GB (2Rx4)N/AIndependent/mirroring1LM+Vol128 GB2 or 2+2
16 x 64 GB (2Rx4)Independent/mirroring1LM+Vol128 GB2 or 2+2
16 x 96 GB (2Rx4)N/AMirroring1LM+Vol96 GB2 or 2+2
16 x 96 GB (2Rx4)Mirroring1LM+Vol96 GB2 or 2+2
16 x 128 GB (2Rx4)N/AIndependent/mirroring1LM+Vol128 GB2 or 2+2
N/AIndependentHetero128 GB2+2
16 x 128 GB (2Rx4)Independent/mirroring1LM+Vol128 GB2 or 2+2