Skip to main content

Remove the server from the rack (friction rails)

Follow instructions in this section to remove the server from the rack.

S036




18 - 32 kg (39 - 70 lb)32 - 55 kg (70 - 121 lb)
CAUTION
Use safe practices when lifting.
R006
No weight on shelf
CAUTION
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended for use as a shelf.
CAUTION

  • Potential stability hazards exist. The rack might tip over and cause serious personal injury.

  • Before extending the rack to the installation position, read the Installation Guidelines. Do not put any load on the slide-rail mounted equipment in the installation position. Do not leave the slide-rail mounted equipment in the installation position.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

CAUTION
Make sure to have three people operate the server removal procedures to prevent injury.

Procedure

  1. Loosen the two screws located on the rack latches to disengage it from the rack.
    Figure 1. Loosening screws in rack latches

    Rack front


    Disengage server from the rack

    1. Flip down the covers on the rack latches.
    2. Loosen the screws that secure the server.
  2. Slide the server all the way out until it stops and remove it from the outer rails.
    CAUTION
    Make sure three people are lifting the sever by holding the 1 lift points.
    Figure 2. Lifting up the server

    Rack front


    Lifting up the server

    Figure 3. Removing the server

    Rack Front


    Pulling out the server

    1. Slide the server out until the release latches are accessible.
    2. Press the release latches.
    3. With three people, slide the server out to remove it from the outer rails. Place the server on a flat and sturdy surface.
  3. Remove the inner rails from the server.
    Figure 4. Removing the inner rails

    1. Flip the touch point to unlock the inner rail.
    2. Push the inner rail backwards until the T-pins on the server disengaged from the inner rail.
  4. Repeat the previous step to the other rail.
After you finish

Carefully lay the server on a flat, static-protective surface.