Remove a super capacitor module from the internal riser kit

Use this information to remove a super capacitor module from the internal riser kit.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before removing a super capacitor module from the internal riser kit:

1. Remove the top cover. See Remove the top cover.

2. Remove the M.2 module if installed. See Remove the M.2 adapter and M.2 drive

3. Remove the internal riser assembly. See Remove the internal riser card.

4. Disconnect the cable of the super capacitor module.

To remove a super capacitor module, complete the following steps:

1. Open the retention clip on the super capacitor holder, and take the super capacitor module out of the holder.
   Figure 1. Super capacitor module removal
   

   

   
   
2. Remove the super capacitor holder as shown if necessary.
   Figure 2. Super capacitor holder removal