Skip to main content

Remove the rear 2.5-inch drive cage

Use this information to remove the rear 2.5-inch drive cage.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening
Before removing the rear drive cage:

  1. Remove the top cover. See Remove the top cover.

  2. Disconnect the cables from the rear drive cage.

  3. Remove all the installed drives and fillers (if any) from the drive bays. See Remove a hot-swap drive.

To remove the rear drive cage, complete the following steps:

Figure 1. Removing the rear 2.5-inch drive cage
Removing the rear 2.5-inch drive cage

  1. Twist and pull out the blue plunger.
  2. Slide the drive cage towards the rear of the chassis to release it.
  3. If needed, remove the backplane from the drive cage. See Middle/Rear backplane replacement.
After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube