Skip to main content

Install a RAID flash power module (lower tray)

The lower RAID flash power module is in the lower compute tray that is accessed from the front of the server. Insert the RAID flash power module in its carrier; then, connect the cable.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Complete the following steps to install a lower tray RAID flash power module:

Figure 1. Lower RAID flash power module installation
Lower RAID flash power module installation

  1. Insert the end of the RAID flash power module into its carrier on the compute tray.
  2. Connect the cable to the RAID flash power module.
  3. Rotate the RAID flash power module down into the carrier until the tab clicks in place to secure it.

After you have installed the lower RAID flash power module:

  1. Make sure that all cables are correctly routed. See Cable routing for drives and Cable routing for common components.

  2. Install the lower fan cage. See Install a fan cage (lower tray).

  3. Install the lower compute tray or place it in the normal operating position; then, install the front cover. See Install a compute tray and Install the front cover.

Demo video

Watch the procedure on YouTube