Skip to main content

Disassemble the M.2 interposer and drive

Use this information to disassemble the M.2 interposer and drive.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems. Place the parts on a static-protective surface.

Procedure

  1. Remove the hot-swap M.2 interposer and drive assembly from the chassis, see Remove hot-swap M.2 interposer and drive assembly.
  2. Disassemble the M.2 interposer from M.2 drive.
    Figure 1. Disassembling M.2 interposer from drive

    1. Loosen one screw that locks the M.2 drive assembly.
    2. Lift one side of the drive assembly as illustrated above.
    3. Disengage the connectors.
  3. Remove M.2 drive assembly.
    Figure 2. Removing M.2 drive

    1. Loosen four screws that lock the M.2 drive and a heat sink.
    2. Lift the heat sink off the drive tray.
    3. Lift the drive off the drive tray.
  4. Clean up the residue of the thermal pads.
    Figure 3. Cleaning thermal pads

    1. Clean up the thermal pad residue on the back of the heat sink with an alcohol cleaning towel.
    2. Peel off the pad on the drive tray.
    3. Clean up the residue by swiping with an alcohol cleaning towel in one direction.
  5. Remove the M.2 interposer.
    Figure 4. Removing M.2 interposer

    1. Loosen four screws that lock the M.2 interposer.
    2. Lift the interposer off the interposer tray.

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.