Remove rear hot-swap M.2 interposer and drive assembly
Follow the instructions in this section to remove rear hot-swap M.2 interposer and drive assembly.
About this task
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.
Procedure
Remove the rear M.2 interposer and drive assembly.
Figure 1. Removing rear M.2 drive assembly


Slide the release latch to the right to open the drive tray handle.
Slide the drive out of the drive bay.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Give documentation feedback