Skip to main content

Remove the support bracket

Follow the instructions in this section to remove the support bracket.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices, disconnect the power cords from the primary chassis, then disconnect the power cords from the secondary chassis. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • If the server is installed in a rack, remove the server from the rack. See Remove the server from rails.

Procedure

  1. Make preparation for the task.
    1. Remove the front top cover. See Remove the front top cover.
    2. Remove the upper processor board (CPU BD) air baffle. See Remove the upper processor board (CPU BD) air baffle.
    3. Remove the upper processor board (CPU BD). See Remove the upper processor board (CPU BD).
  2. Remove the support bracket.
    Figure 1. Removing support bracket

    Removing support bracket
    1. Loosen the two screws that secure the support bracket.
    2. Grasp the support bracket and remove it from the lower processor board (MB) handle.

After you finish

  1. Install a replacement unit. See Install the support bracket.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube