Skip to main content

Install a 2.5-inch drive backplane

Follow the instructions in this section to install a 2.5-inch hot-swap drive backplane.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Note

  • The server supports up to four 2.5-inch hot-swap drive backplanes.

  • See Technical rules for system fans for detailed information about the storage limitations in different server configurations.

  • Before installing the drive backplane:

    1. Determine the location of the backplanes to be installed. Backplanes are installed in the following order:

      • The installation priority of different backplane types is: NVMe > AnyBay > SAS/SATA.

      • The installation order of SAS/SATA backplanes is Backplane 1 > Backplane 2 > Backplane 3 > Backplane 4, from bottom to top when viewed from the front of the server.

      • The installation order of NVMe backplanes is Backplane 4 > Backplane 3 > Backplane 2, from top to bottom when viewed from the front of the server.

        Note

        Depending on models, the server supports up to three 2.5-inch NVMe backplanes.

      • The server supports up to one AnyBay backplane. The location of the AnyBay backplane follows the rules below:

        • Install the AnyBay backplane to the first available drive cage counted from top when viewed from the front of the server.

          • When one AnyBay backplane mixes with SAS/SATA backplanes, install the AnyBay backplane as Backplane 4.

          • When one AnyBay backplane mixes with NVMe backplanes, install the NVMe backplanes first, and then install the AnyBay backplane to the first available drive cage counted from top when viewed from the front of the server.

Procedure

  1. Determine the slot for the backplane to be installed in. See 2.5-inch drive cable routing.
  2. Install the backplane.
    1. Insert the backplane into the backplane slot with an angle as shown.
    2. Pivot the backplane carefully toward the drive cage until it is secured by the release tabs.
    Figure 1. Installation of a 2.5-inch drive backplane
    Installation of the 2.5-inch drive backplane

After you finish

Demo video

Watch the procedure on YouTube