Skip to main content

Install an optical drive cage

Follow the instructions in this section to install an optical drive cage.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

Install the optical drive cage.
  1. Lift and hold the blue retention tab.
  2. Meanwhile, carefully push the optical drive cage into the bay until it snaps into position.
    Figure 1. Installation of an optical drive cage
    Optical drive cage installation

After this task is completed

  1. Install all the optical drives, tape drives, and fillers (if any) into the optical drive cage. See Install an optical drive or a tape drive and Install a 5.25-inch drive bay adapter assembly.

  2. Reinstall the front bezel. See Install a front bezel.

  3. Reinstall the security door. See Install the security door.

  4. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube