Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps:

1. Read the safety information that begins in Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices.
3. Disconnect all power cords; then, disconnect all external cables from the server.
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
   Attention

   Do not allow the server to fall over.
5. Unlock and remove the left-side cover (see Removing the left-side cover).
6. See the documentation that comes with the adapter for any cabling instructions and information about jumper or switch settings. It might be easier for you to route cables before you install the adapter.
7. Remove the air baffle if installed (see Removing the air baffle).
8. Locate the DIMM connectors on the system board (see System-board internal connectors).
   Attention

   To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently.
9. Move the DIMM retaining clips on the side of the DIMM connector to the open position by pressing the retaining clips away from the center of the DIMM connector.
   
   
10. Using your fingers, lift the DIMM out of the DIMM connector.
11. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.