Skip to main content

Removing the front USB connector and operator information panel assembly

Use this information to remove the front USB connector and operator information panel assembly.

To remove the front USB connector and operator information panel assembly, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
  3. Disconnect all external cables and power cords.
  4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
    Attention
    Do not allow the server to fall over.
  5. Remove the left-side cover (see Removing the left-side cover).
  6. Remove the air baffle (see Removing the air baffle).
  7. Remove the fan assembly (see Removing the fan assembly).
  8. The USB connector and operator information panel assembly shown as the illustration.


  9. Press the handle and pull the USB connector and operator information assembly backward out of the server shown as the illustration.


  10. If you are instructed to return the USB connector and operator information assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.