Skip to main content

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.

To remove a hypervisor flash device, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server.
  3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
    Attention
    Do not allow the server to fall over.
  4. Unlock and remove the left-side cover (see Removing the left-side cover).
  5. Remove the air baffle (see Removing the air baffle).
  6. Unlock the retention latch by pushing it down toward the system board.


  7. Grasp the flash device and pull to remove it from the connector.
  8. Return the retention latch to the locked position by pulling it away from the system board.


  9. If you are instructed to return the flash device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.