Replacing the DVD drive cable

Use this information to replace the DVD drive cable.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
3. Remove the cover (see Removing the cover).
4. Remove the air baffle (see Removing the air baffle).
5. Align the cable connector with the connector on the rear of the DVD drive cage. Press the cable connector into the DVD drive cage connector and slide it to the left until it is firmly seated.
   Figure 1. DVD drive cable latch
   

   

   
   

   The following illustration shows cable routing for the DVD cable:

   Attention

   Follow the DVD drive cable routing as the illustration shows. Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.

   Figure 2. DVD drive cable routing for 2.5-inch hard disk drive server models
   

   

   
   
   Figure 3. DVD drive cable routing for 3.5-inch hard disk drive server models
   

   

   
   
6. Replace the air baffle (see Replacing the air baffle).
7. Reinstall the cover (see Replacing the cover).
8. Slide the server into the rack.
9. Reconnect the power cords and any cables that you removed.
10. Turn on the peripheral devices and the server.