Replacing a USB embedded hypervisor flash device

Use this information to replace a USB embedded hypervisor flash device.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see Removing the cover).
4. Align the flash device with the connector on the system board and push it into the USB connector until it is firmly seated.
   Figure 1. USB hypervisor flash device installation
   

   

   
   
5. Reconnect the power cords and any cables that you removed.
6. Reinstall the cover (see Replacing the cover).
7. Slide the server into the rack.
8. Turn on the peripheral devices and the server.