Removing the front video connector assembly

Use this information to remove the front video connector assembly.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
3. Remove the cover (see Removing the cover).
4. Remove the media cage (see Removing the media cage).
5. Loosen the screws that secure the front video connector assembly to the media cage; then, remove the assembly from the media cage.
   Note

   Refer to the illustration that applies to your particular server configuration.

   Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:

   Figure 1. Front video connector assembly removal for eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration
   

   

   
   

   Ten 2.5-inch hot-swap hard disk drive server configuration:

   Figure 2. Front video connector assembly removal for ten 2.5-inch hot-swap hard disk drive server configuration
   

   

   
   

   Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:

   Figure 3. Front video connector assembly removal for four 3.5-inch hot-swap or simple-swap hard disk drive server configuration
   

   

   
   
6. If you are instructed to return the front video connector assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.