Skip to main content

Replacing the ServeRAID adapter memory module

Use this information to replace the ServeRAID adapter memory module.

To install the ServeRAID adapter memory module, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the cover (see Removing the cover).
  4. Connect the cable to the ServeRAID adapter memory module.
    Figure 1. Cable installation
    Cable installation
  5. Align the memory module with the retention pins. Install the ServeRAID adapter memory module into the system board.
    Figure 2. ServeRAID adapter memory module installation
    ServeRAID adapter memory module installation
  6. Connect the other end of the cable to the flash power module.
    Figure 3. Cable installation
    Cable installation
    Note
    Make sure the flash power module is seated properly (see Replacing a RAID adapter battery or flash power module).
  7. Reconnect the power cords and any cables that you removed.
  8. Reinstall the cover (see Replacing the cover).
  9. Slide the server into the rack.
  10. Turn on the peripheral devices and the server.