Replacing the rear two hard-disk-drive kit

Use this information to replace the rear two hard-disk-drive kit on the system board.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see Removing the cover).
4. Reinstall any adapters and reconnect any internal cables you might have removed in other procedures (see Replacing an adapter and Internal cable routing and connectors).
5. Align the rear two hard-disk-drive kit with the connector on the system board:
   Figure 1. Rear two hard-disk-drive kit installation
   
   
6. Press down on the kit. Make sure that the kit is fully seated in the connector on the system board.
7. Replace the cover (see Replacing the cover).
8. Slide the server into the rack.
9. Reconnect the power cords and any cables that you removed.
10. Turn on the peripheral devices and the server.