Skip to main content

Install the leakage sensor module bracket

Follow the instructions in this section to install the leakage sensor module bracket. The procedure must be executed by a trained technician.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Align and insert the leakage sensor module bracket into the slot until it is securely seated. Fasten the four M3 screws (PH2, 4 x M3, 0.5 newton-meters, 4.3 inch-pounds) to secure it in place.
    Figure 1. Installing the leakage sensor module bracket
    Installing the leakage sensor module bracket
  2. Fasten only two M3 screws (PH2, 2 x M3, 0.5 newton-meters, 4.3 inch-pounds) if rear drive cage is to be installed.
    Figure 2. Installing the leakage sensor module bracket (with rear drive cage)
    Installing the leakage sensor module bracket (with rear drive cage)

After you finish

  1. If applicable, reinstall the rear drive cage. See Install the rear drive cage.
  2. Reinstall the rear top cover. See Install the rear top cover.
  3. Reinstall the front top cover. See Install the front top cover.
  4. Complete the parts replacement. See Complete the parts replacement.