Skip to main content

Remove the MicroSD card

Follow the instructions in this section to remove the MicroSD card.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices, disconnect the power cords from the primary chassis, then disconnect the power cords from the secondary chassis. See Power off the server.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • If the server is installed in a rack, remove the server from the rack. See Remove the server from rails.

Procedure

  1. Make preparation for the task.
    1. Remove the front top cover. See Remove the front top cover.
    2. Remove the upper processor board (CPU BD) air baffle. See Remove the upper processor board (CPU BD) air baffle.
    3. Remove the upper processor board (CPU BD). See Remove the upper processor board (CPU BD).
    4. Remove the support bracket. See Remove the support bracket.
    5. For primary chassis only, remove the system I/O board and interposer assembly. See Remove the system I/O board and interposer board.
  2. Remove the MicroSD card.
    Figure 1. Removing MicroSD card

    Removing MicroSD card
    1. Slide the socket lid to the open position.
    2. Lift open the socket lid.
    3. Remove the MicroSD card from the socket.

After you finish

  1. Install a replacement unit. See Install the MicroSD card.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube