Remove a hard disk drive backplane (upper tray)

Hard disk drive backplanes in the upper compute tray or optional storage tray are accessed from the front of the server. There are several types of hard disk drive backplane. Steps that are backplane specific are noted in each procedure.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

CAUTION

Make sure that all server power cords are disconnected from their power sources before performing this procedure.

Before you remove the hard disk drive backplane:

1. Remove the front cover. See Remove the front cover.

2. After noting their locations, remove any hard disk drives that are installed in the upper tray. See Remove a hard disk drive.

3. Remove the upper compute tray or storage tray. See Remove a compute tray or Remove a storage tray.

4. Turn the tray upside down.

5. Remove the fan cage. See Remove a fan cage (upper tray).

Complete the following steps to remove the hard disk drive backplane:

1. Disconnect all power and data cables on the hard disk drive backplane that go to the storage interposer or to connectors on the system board or optional storage tray. You might find it easier to disconnect cables from the backplane if you disconnect them from the storage interposer first, reconnecting them to the storage interposer after removing the backplane or installing a new one. Other cables might also need to be removed from their retaining clips or moved to the side to remove the backplane.
2. Turn the tray right-side up.
3. Remove the hard disk drive backplane.
   Figure 1. Hard disk drive backplane (upper) removal
   
   

   Grasp the backplane and pull it up and out of the upper tray.